Jecod CP-40 hacking and DIY controller reverse engeneering

I just picked up a Jacod CP-40 gyre but was disappointing to see that the jabeo > apex connector does not work with this unit.. In efforts to figure out a way to work the signal and make my own i decided to do a little reverse engendering and see how it worked.. No keep in mind i’m still learning to use my oscilloscope.. this may be a bit of a leap for me.. but hey its a good time to learn!

 

The connector wiring

connector

 

 

 

 

 

 

 

 

 

 

Backside of controller

cp40-ccontroller

front side of controller

cp40-controller2

 

 

Oscilloscope testing
Yellow line is the yellow wire. Blue is brown wire.

Mode: H1 (constant speed)
Intensity: Lowest
CSV Filecp40-H1-lowspeed

Mode: H1 (constant speed)
Intensity: Full Speed
CSV File
cp40-h1-fullspeed

 

 

Mode: W1 (short pulse Wave mode)
Intensity: Low speed
CSV File

cp40-w1-low

 

Mode: W1 (short pulse Wave mode)
Intensity: Full Speed
CSV Filecp40-w1-fullspeed

 

Mode: W3 (fixed forumla wave)
Intensity: low
CSV Filecp40-w3-low

 

Mode: W3 (fixed forumla wave)
Intensity: full
CSV Filecp40-w3-fullspeed

Leave a Reply

Your email address will not be published. Required fields are marked *